Harbin Rainbow Technology CO.,Ltd.
video site
Button Text
Button Text
NEWS
Ten Questions Buyers Ask Before Ordering a Screw Heading Machine
Source: | Author:Avril Xu | Published time: 2026-11-04 | 213 Views | 🔊 Click to read aloud ❚❚ ▶ | Share:

Ten Questions Buyers Ask Before Ordering a Screw Heading Machine

Almost every heading machine enquiry we receive starts with the same sentence: "We want to make screws." The useful conversation starts about four questions later, when wire range, head type and output target are on the table.

These are the ten questions that actually determine which machine a plant should order — and the answers that make the difference between a line that runs at rated speed and one that is renegotiated six months after installation.

1. How many blows does my part actually need?

One die and two blows covers the great majority of standard screws: one gathering strike, one finishing strike. If your part needs a third or fourth deformation — a long shank, a deep recess with a flange — the honest answer is a different machine class, not a heavier punch.

2. What wire range should I specify?

The range should be stated for the parts you intend to run in the next three years, not only today's. A machine bought at the edge of its wire range has almost no headroom when a new product arrives.

3. Can one machine make both drywall screws and machine screws?

Usually yes within the wire range, because both are two-blow heads. What changes is tooling, not the machine. The exception is when point forming or a special recess needs a separate station.

4. What keeps the head concentric at high stroke rates?

Punch guidance and die rigidity, in that order. A machine can have plenty of tonnage and still produce eccentric heads if the punch is not guided precisely through its stroke. Ask how the punch is guided, not how many tons it delivers.

5. How do I judge cut-off quality?

Ask for a sample cut face. Every cycle begins with the cut, and a poor cut face becomes a defect in the head — a crack, a fold or an off-centre mark — on every single part. It is the cheapest thing to check and the most expensive to live with.

6. What tooling do I need to budget for?

Dies and punches are consumables, and their cost per thousand pieces matters more than their purchase price. Ask for the expected tool life on your material and the lead time for replacements — a three-week die lead time is a production risk, not a purchasing detail. Dies are sourced to match the machine you order, and if you have no drawing, a few sample screws are enough for them to be made.

7. How does the machine pair with a thread roller?

The roller must absorb the header's output, and the pre-roll blank diameter must be calculated from the pitch diameter. If either is wrong, you own the header's speed and ship the roller's. Plan the two as one line, with a short buffer between them.

8. What output can I expect on my part?

Output depends on wire diameter, head complexity, stroke rate and line balance — so it should be calculated on your part and shift pattern during technical review. A single headline figure quoted without your drawing is not a commitment.

9. What maintenance can my own team handle?

On a two-blow header: daily lubrication and die checks, punch and die replacement, feed adjustment. What should not be handled in-house is structural alignment after a crash. Ask what the maintenance schedule looks like for the first year.

10. What should be checked before shipment?

Ask what is verified before shipment, and on which material: stroke rate, reject rate and head dimensions. A machine demonstrated on someone else's sample material proves it runs; it does not prove it runs your product — so the check should be made on material as close to yours as possible.

Related equipment


Company address:No. 1560-2 chuangxin 2nd road, songbei district, Harbin.

Mailbox:chen@rainbowtechnology.net

+86-451-51066797